Laser marking system for plastics, PCB, stainless steel, aluminum. Flat, round surfaces or continuous tape roll to roll.
Laser marking generator
- AUREL Nd-Yag with acousto-optic Q-switch
- Wave lenght 1064 nm
- Power TEMoo CW 12W
- Multimode CW 40W
- Repetition rate Single pulse to 10 KHz
- Alignment either by HeNe Laser or through collimator
- All mirrors and optical components mounted on rails with micrometric adjustment
- Vertical and horizontal alignment of the Q-switch by micrometers
| Laser marking specification | |
|---|---|
| Working area | 110 x 100 mm (150 x 150 mm optional) |
| Resolution | 10 µm |
| Repeatibility | 30 µm Writing speed: 350 chr/sec. Scanner speed: ScanLab Mod. Hurryscan |
| Computer | Pentium III 450 MHz, 128 Mb RAM, CD-rom, 15″ TFT Flat monitor, Keyboard with trackball, Windows 95/98 |
| Software | SAM Light SCAPS * |
| I/O Interfacing signal | Start/Stop marking cycle (input) Beginning/End marking cycle (output) Emergency (input) Fault (output) Piece rotation (optional) |
∗= link SAM Light SCAPS
| Requirements | |
|---|---|
| Electrical power | 3/380V – 20A – 50 Hz |
| Operating temperature | 10÷40°C |
| Humidity | 85% max |
Download (information): Aurel Laser ALS6100
